Skip to content
Appliance Error Codes

What Does 26E Error Mean on Samsung RS27T5200SR?

Error 26E on Samsung RS27T5200SR: Ice maker function error - ice maker not producing or dispensing ice. Follow the troubleshooting steps below to diagnose and fix this refrigerator issue. The 26E error code on your Samsung RS27T5200SR refrigerator indicates a malfunction in the ice maker system. The control board has detected that the ice maker is not operating within expected parameters. First check that the freezer temperature is set to 0°F (-18°C) or colder, and that the ice maker arm or switch is in the ON position. ## What Does 26E Mean? The 26E error code signals a general ice maker fault on the Samsung RS27T5200SR. The ice maker system involves several components: the water inlet valve that supplies water, the ice mold and heating element that releases ice, the ice maker motor that drives the harvest cycle, and the ice maker control board that coordinates the entire process. On the RS27T5200SR with its SpaceMax Technology and in-door ice and water dispenser, the ice maker is one of the most complex subsystems. The 26E error appears when the control board detects that the ice maker has not completed a harvest cycle within the expected timeframe or has reported an abnormal operating condition. Common causes include insufficient freezer temperature (the ice maker requires 0°F or below to freeze water in the ice mold), a frozen water supply line, or a mechanical failure in the ice maker’s motor or harvest heater. The ice maker door gasket condition also affects performance, as warm air infiltration can prevent the freezer from reaching the temperatures required for ice production. Before scheduling service, verify the basic operating conditions: freezer temperature at or below 0°F (-18°C), water supply connected and turned on, and the ice maker arm or control switch in the ON/active position. ## Possible Causes 1. Freezer temperature above the minimum required for ice production (above 10°F / -12°C) 2. Water supply line frozen, kinked, or shut off, preventing water from reaching the ice maker 3. Ice maker water inlet valve has failed and cannot open to supply water 4. Ice maker harvest motor has failed, preventing completed harvest cycles 5. Door gasket deterioration allowing warm air to raise freezer temperature 6. Ice level sensor or arm is stuck in the OFF/full position even when the bin is empty 7. Control board communication error between main board and ice maker module ## Troubleshooting Steps | Step | Action | Expected Result | |------|--------|------------------| | 1 | Check the freezer temperature display and verify it reads 0°F (-18°C) or colder | Temperature at or below 0°F is required for ice production | | 2 | Confirm the ice maker arm or control switch is in the ON (down) position | Ice maker is enabled to produce ice | | 3 | Check the water supply valve behind or under the refrigerator is fully open | Water flows freely to the refrigerator water line | | 4 | Inspect the water supply line for kinks or ice blockage | Water line is clear and flexible with no frozen sections | | 5 | Reset the ice maker by pressing and holding the TEST or RESET button on the ice maker module for 3 seconds | Ice maker initiates a test harvest cycle, filling with water and dropping test cubes | Never attempt to manually break ice out of the ice maker mold with tools. This can damage the mold, the harvest heater, or the thermostat. If the mold is frozen solid, allow the natural harvest heater cycle to release the ice, or perform a full refrigerator defrost. ## When to Call a Technician Contact Samsung authorized service if: - Freezer temperature is at or below 0°F but no ice is being produced

  • The water supply line and valve are confirmed open and functional
  • The ice maker TEST cycle completes but no ice falls into the bin
  • Ice is stuck in the mold and a harvest heater failure is suspected Professional repair costs for 26E issues typically range from $100 to $350 depending on the specific component and your service region. ## Frequently Asked Questions ### Why does the 26E error appear even though my freezer seems cold? The ice maker requires the freezer to reach 0°F (-18°C) or below. If the thermostat reads 10°F or even 5°F, the ice maker will not function and can trigger 26E. Check the actual thermometer reading, not just the set temperature, to confirm the freezer is cold enough.

How do I run the ice maker test cycle on my RS27T5200SR? Press and hold the TEST or RESET button on the ice maker module (usually a button or switch on the front or side of the ice maker assembly) for 3 seconds. The ice maker will run a complete test cycle, filling the mold with water, freezing, and dropping test cubes. This confirms whether the mechanical harvest cycle is working.

Section titled “How do I run the ice maker test cycle on my RS27T5200SR? Press and hold the TEST or RESET button on the ice maker module (usually a button or switch on the front or side of the ice maker assembly) for 3 seconds. The ice maker will run a complete test cycle, filling the mold with water, freezing, and dropping test cubes. This confirms whether the mechanical harvest cycle is working.”

Can a dirty water filter cause the 26E ice maker error? A severely clogged water filter can restrict water flow to the ice maker, preventing the mold from filling completely. If your RS27T5200SR water filter has not been replaced in over 6 months, try replacing it and resetting the ice maker before scheduling service.

Section titled “Can a dirty water filter cause the 26E ice maker error? A severely clogged water filter can restrict water flow to the ice maker, preventing the mold from filling completely. If your RS27T5200SR water filter has not been replaced in over 6 months, try replacing it and resetting the ice maker before scheduling service.”

How long should I wait after resetting the ice maker before expecting ice? After a test cycle reset or after resolving a water supply issue, allow 24 to 48 hours for the RS27T5200SR to resume normal ice production. The first batch of ice should appear within 4-6 hours if the system is functioning correctly, with full production resuming over the following day. Reference: Samsung official support documentation (samsung.com/us/support) and authorized service guides ### Is it safe to keep using my Samsung RS27T5200SR with error 26E? If error 26E does not indicate an immediate safety hazard such as a gas leak, electrical short, or water flooding, you can continue limited use while monitoring the appliance. However, running the refrigerator with an active error code increases the risk of further damage. Address the underlying issue as soon as possible. For high-severity errors, disconnect the appliance and contact a qualified technician. ### How much does it cost to fix error 26E on a Samsung RS27T5200SR? Repair costs for error 26E on the Samsung RS27T5200SR refrigerator depend on the root cause. DIY fixes such as cleaning filters, resetting the unit, or reconnecting loose wires cost nothing beyond basic tools. If a component replacement is needed, parts and labor from a certified technician are the main expenses. Contact a Samsung-authorized service provider for an accurate estimate based on your specific situation. ### What does error code 26E mean on a Samsung refrigerator? Error code 26E on Samsung refrigerator models indicates Ice maker function error - ice maker not producing or dispensing ice. This error is detected by the appliance’s internal diagnostic system and displayed to alert the user that attention is needed. Refer to the troubleshooting steps above for guidance on resolving this issue.

Section titled “How long should I wait after resetting the ice maker before expecting ice? After a test cycle reset or after resolving a water supply issue, allow 24 to 48 hours for the RS27T5200SR to resume normal ice production. The first batch of ice should appear within 4-6 hours if the system is functioning correctly, with full production resuming over the following day. Reference: Samsung official support documentation (samsung.com/us/support) and authorized service guides ### Is it safe to keep using my Samsung RS27T5200SR with error 26E? If error 26E does not indicate an immediate safety hazard such as a gas leak, electrical short, or water flooding, you can continue limited use while monitoring the appliance. However, running the refrigerator with an active error code increases the risk of further damage. Address the underlying issue as soon as possible. For high-severity errors, disconnect the appliance and contact a qualified technician. ### How much does it cost to fix error 26E on a Samsung RS27T5200SR? Repair costs for error 26E on the Samsung RS27T5200SR refrigerator depend on the root cause. DIY fixes such as cleaning filters, resetting the unit, or reconnecting loose wires cost nothing beyond basic tools. If a component replacement is needed, parts and labor from a certified technician are the main expenses. Contact a Samsung-authorized service provider for an accurate estimate based on your specific situation. ### What does error code 26E mean on a Samsung refrigerator? Error code 26E on Samsung refrigerator models indicates Ice maker function error - ice maker not producing or dispensing ice. This error is detected by the appliance’s internal diagnostic system and displayed to alert the user that attention is needed. Refer to the troubleshooting steps above for guidance on resolving this issue.”