Haier GE GFW510SCN0 Washer

Model Overview

The Haier GE GFW510SCN0 is a high-efficiency front-load washer designed for residential use, offering advanced features like inverter motor technology and precise water level control. This model includes comprehensive self-diagnostic capabilities with a detailed error code system to simplify troubleshooting.

Error Codes

Error Code	Description
0	No Faults; Displayed in Service Mode only when there are no faults to display
1	Lock Monitor; This fault is set if the motor shaft speed exceeds 45 RPM for 5 seconds
2	Door Monitor; Control did not get Door closed signal from switch while motor was running
8	Pressure Sensor Loss; Determines if appropriate pressure changes are seen during fill
9	Door Switch Redundancy; Three cycles have been completed without any door opening events
18	Drain Pump Clearing Algorithm Failed; Pressure sensor indicates water in the tub after drain
19	UI State Timeout; This will happen if a cycle is paused for greater than 24 hours
20	Critical Flood Level by Gallons; Water volume into the tub exceeded 41 gallons at any time
22	Out of Balance (OOB) During Dry Load Sense; Large wet/OOB load being washed
24	Door Logic Failure; Door lock failure. This fault is set if the system perceives inconsistent door states
25	Pressure Sensor Dropout, Pressure Sensor Continuous Gallons Monitor; This fault is set if pressure sensor readings are inconsistent
26	Out of Balance (OOB) Ended Final Spin; Washer detected an out of balance load and aborted spin
27	IMP Overheated; Inverter over temperature (> 221°F) for 5 seconds
29	Drive System Self-Check Fault; MCU failed self-check
30	Main Board Over Voltage; When connected to power, voltage is higher than 160 VAC
31	Main Board Self Check Failed; MCU failed self-check
35	Accelerometer Faults; Any of these faults can be set if the accelerometer fails self-test
57	Door Lock Fault Water Above Door by Pressure; This fault is set when door is unlocked with water above door level
58	ADC Health Check Fault; After drain control should go to idle End Cycle ADC Health Check Fault
62	Inverter Power And Door Lock Monitor; The fault is set when the system request inverter power but door is not locked
70	Inverter Volt/ Hertz Start Up; Inverter volt hertz star up 135 is set five times in a row
77	See Fault Code 32
78	Board Communication API Mismatch; The Main Board detects that it doesn’t have the correct API version
85	Voltage Detected by MC; Voltage detected by MC is outside acceptable window

Common Issues

Excessive vibration during spin – Often caused by an unbalanced load. Redistribute clothes evenly.
Drain pump failures (Error 18) – Check for clogs in the drain hose or pump filter.
Door lock faults (Error 24, 57) – Inspect door latch mechanism and ensure proper alignment.
Overheating inverter (Error 27) – Verify proper ventilation around the washer and avoid overloading.
Pressure sensor errors (Error 8, 25) – Ensure water supply pressure is within range and inspect sensor connections.

Technical Specifications

Type: Front-load washer
Capacity: 4.5 cu. ft.
Motor: Inverter-driven direct drive
Voltage: 120V AC, 60Hz
Water Levels: Multiple precision-controlled levels
Cycle Options: Includes heavy-duty, quick wash, and delicate cycles
Diagnostics: Self-diagnostic error code system
Flood Protection: Automatic shutoff if water exceeds 41 gallons (Error 20)
Compliance: Meets ENERGY STAR® efficiency standards