Haier GE GDF450P R0 Series Dishwasher
Model Overview
Section titled “Model Overview”The Haier GE GDF450P R0 Series is a built-in dishwasher designed for residential use, featuring multiple wash cycles and energy-efficient operation. This model includes advanced diagnostics with error code displays for troubleshooting common issues. Its compact design accommodates standard place settings while maintaining quiet performance.
Error Codes
Section titled “Error Codes”| Error Code | Description |
|---|---|
| 2 | Adc or HrF; Internal Board Failure; Replace machine control board. Power cycle t |
| FTD | Failure to Drain; Check for clog in air gap/disposer, drain hoses, and drain |
| H20 | Water Supply Failure; Verify the water supply line is connected properly, the |
| ACF | High Supply Voltage; Check the supply voltage. Supply voltage is greater than |
| PRS | Pressure Sensor Failure; Verify pressure sensor harness has continuity. Unplu |
| F32 | Water Level Sensor Invalid; Check to see if pressure sensor is plugged in. If so |
| F36 | CSM Tripped (CSM Lock Out); Entering Circulate Test or Heater Test will Reset th |
| F60 | Heater Relay Stuck On Fault; Clear faults and cycle power to unit. If fault reoc |
| F61 | CSM Check Failed; Cycle power and start cycle to clear fault. If fault does not |
| F63 | Flood Condition Fault; The pressure sensor has detected the water level above th |
| F86 | No Fill Failure; Check water valve to see if a water source is hooked up to the |
| F96 | Ignore Fault; Ignore fault. |
| F154 | Door Latch Diagnostic; Replace machine control board. |
| F155 | Tactile Key Stuck; Check button operation, each button should “click”. Check for |
| F158 | Overvoltage; An overvoltage condition has been detected by the control. Check in |
Common Issues
Section titled “Common Issues”- Drainage Problems: Often caused by clogs in the drain hose or air gap. Inspect for debris and ensure proper installation.
- Water Supply Failures: Check for kinks in the inlet hose or low water pressure from the household supply.
- Control Board Errors: Persistent internal faults may require board replacement or professional servicing.
- Pressure Sensor Issues: Faulty readings lead to incorrect water level detection; verify sensor connections.
- Heater Malfunctions: Relay faults or sensor errors can disrupt heating; power cycling may temporarily resolve.
Technical Specifications
Section titled “Technical Specifications”- Type: Built-in dishwasher
- Capacity: Standard place settings (varies by configuration)
- Wash Cycles: Normal, Heavy, Rinse, Eco, and more
- Voltage: 120V AC (check local requirements)
- Water Pressure Requirement: 20-120 psi
- Noise Level: ≤50 dB (varies by cycle)
- Dimensions: Standard 24-inch width (exact measurements vary)
- Diagnostics: LED error code display
- Compatibility: Standard household plumbing connections